Sheet Goods Panel Grid Yield Calculator
Compare original and 90-degree rotated rectangular grid layouts including saw kerf.
YOUR SHORTCUTS
Continue where you left off
Recently used
Your favorites
These shortcuts remember only calculator names on this device, not the values you enter.
Actual sheet edges, panel size and cutting kerf
Schematic only · not to scale. Enter your actual measurements below; the diagram explains which dimensions to take.
Sheet Goods Panel Grid Yield Calculator
View complete schedule
ⓘ Calculated locally in your browser. Results depend on the values and units you enter.
Sheet cutting grid
Shows the better of two uniform grid orientations. Grain direction, mixed rotations and defects are excluded.
Reading measurements…
Units: mm. Dimension-scaled reference layout. Check defects, cutting order, remnant quality, safety and real stock. Project files remain on your device.
How this calculator works
For each orientation, columns=floor((sheet width+kerf)/(part width+kerf)), rows=floor((sheet length+kerf)/(part length+kerf)). Show the better all-one-orientation grid. Does not optimize mixed rotations, grain/face direction, edge trim, defects or nesting. Planning quantities only; check real stock size, load-bearing design, applicable codes and fastening recommendations.
Formula and reasoning
Panels per sheet = max[ floor((sheetL+kerf)/(partL+kerf)) × floor((sheetW+kerf)/(partW+kerf)), floor((sheetL+kerf)/(partW+kerf)) × floor((sheetW+kerf)/(partL+kerf)) ]; all lengths in mm; uniform 0° or 90° grid, no mixed rotations.
- 1. Start with the measurementsSheet length (mm)2440Sheet width (mm)1220Part length (mm)600Part width (mm)400Kerf between neighboring pieces (mm)3
- 2. Substitute into the formula
Sheet length (mm) = 2440 ? Sheet width (mm) = 1220 ? Part length (mm) = 600 ? Part width (mm) = 400 ? Kerf between neighboring pieces (mm) = 3
- 3. Check the computed answer
Result for the sample inputs
Worked example
Frequently asked questions
What do I measure?
For each orientation, columns=floor((sheet width+kerf)/(part width+kerf)), rows=floor((sheet length+kerf)/(part length+kerf)). Show the better all-one-orientation grid. Does not optimize mixed rotations, grain/face direction, edge trim, defects or nesting.
Is this a structural design approval?
Planning quantities only; check real stock size, load-bearing design, applicable codes and fastening recommendations.
Results are informational and assume the stated inputs and formulas. Double-check critical financial or engineering decisions with a qualified professional.
Was this calculator helpful?
Your feedback helps you keep track of useful tools on this device.
Your selection stays in this browser. No public vote count is shown.
Prefer EverydayCalc on Google
Opens Google source preferences. Availability and placement are determined by Google; this does not guarantee higher rankings.